I did post this in another thread, and was informed that this should have been set to ON. See below: SW1-2 Low Heat Only (Adaptive Heat Mode) - OFF I have a two-stage Nest thermostat with W2 wire connected that is capable of controlling the staging. Based on my current knowledge I'm questioning some of the dip switch settings that were configured for my new furnace. Following the installation I read the furnace installation manual and have read the forums including asked questions of my HVAC tech about the installation which on hindsight I should have done earlier. Hi there, I recently had a new Payne PG96VAT 2-stage/variable speed furnace installed along with a Honeywell small bypass humidifier and third generation Nest learning thermostat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |